Here goes you will need:
Fundamentals SD Card
Basic Grey Pattern Paper
And Basic Grey solid paper
Tim Holtz Winter Wonderland die
3L Dimensional adhesive
Using the Fundamentals SD card set the pressure to 4, tabs to two and width at 3. Insert your basic grey pattern paper into the eCraft and then position your blade into the bottom left hand corner. Select Category 2 (Frames) Image 19 and change the size to 4 inches. Press cut. ;)
Next using the Winter Wonderland die from Tim Holtz and solid white cardstock run it through the eBosser and you will get this adorable little snowman. He comes with a nose pointing out to the side so I just took my kraft knife and snipped that part off. Next stamp an adorable Peachy Keen Face on him! Dab a small amount of pink chalk onto each cheek and color in his mouth and nose using orange and red copics (or any marker you have on hand) Tie some twine through a blue button and knot it in the front. Punch two holes in the middle of his stomach and attach glitter brads. Attach the frame and the snowman with 3L dimensional adhesive. I LOVE the side effect of this card because it has just enough umph! Voila you are all finished!!!
I hope to see your wonderful Christmas cards! If you make some please leave us a link in the comments section so that we can all go over and check them out!